The
high pressure pump: Full abrasive waterjet cutting system consists of high
pressure pump, cutting table with hopper, and CNC controller.
Pump
type
|
dual plunger reciprocal intensifier
|
Maximum pressure
|
400Mpa (60kpsi)
|
Pump cooling method
|
forced
water flow, electrical chiller is optional.
|
Maximum
water flow rate
|
3.5L/minute (0.8Gal/min)
|
Water Filter
|
2-stage water
filtration included.
|
Minimum supply water pressure
to pump
|
70psi (5kg/cm2)
|
Approximate size
|
60" x 36"x 55"(1600 x900 x1400mm), weight 1100kg
|
Power source
|
3 phase,
380VAC, 50Hz (or 220V 60Hz),220VAC or 60Hz (380VAC, 50Hz)
|
Pump cooling method
|
water. Oil chiller is optional
|
Motor starting current requirement
|
160Amp
|
Protective automatic shut off under the following circumstances
|
Over pressure limit |
Over temperature limit
|
Cutting head |
|
Pneumatically
operated on/off valve, self-aligned cutting head. Maximum Abrasive flow
rate: 0.5kg/min (1lb/min).
Compressed air source is necessary. An air
compressor is optional item from manufacturer. As an option, the cutting head
can manually tilt in both x and y directions. |
This equipment is highly recommended for large tables |
 |
Requires 70psi
pneumatic source |
| Capacity 40
Gallon. |
| Self detecting
empty/full status of reservoir and start/stop feeding. |
| Model number
ADS-04-170 |
Mini hopper |
|
Mini
hopper is used as a bridge between the automatic abrasive feeder and the
cutting head. The mini hopper also includes a valve to control the flow of the
abrasive. |
Stainless Steel tubing (optional) |
|
The tubing connects the high pressure pump to the cutting head. |
System connection diagram
|
